Grasshopper

algorithmic modeling for Rhino

helix starting point

hello.

I can't understand how to set the starting point of my helix, now is set on 0,0,0 , but i would like to set different points.

any suggestions?

 

thenk you.

Views: 941

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on September 21, 2010 at 4:25am

Permalink Reply by paul piciorul on September 21, 2010 at 4:30am
yes!
thank you very much.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service