Hatches not loading in Grasshopper

Anyone have any solutions for Hatches not loading in Grasshopper properly? Both Human and Fabtools' Hatch components are not loading anything but a single "Solid" hatch instead of the default hatches that are installed with Rhino. Hatches are working in Rhino so I know they are installed. Nothing has changed about my setup recently and hatches were working fine until now. I've tried restarting Rhino and computer but nothing.

Replies to This Discussion

Permalink Reply by Andrew Kudless on August 13, 2014 at 8:37pm

OK, if this comes up for others, Andrew Heumann and I found two solutions and a possible cause:

First the cause: It appears that when Rhino is updated, something strange happens with the hatch table and grasshopper loses it's connection with it. Andrew was able to re-establish the connection by using the desired hatch pattern in the current Rhino document and then refreshing the hatch table in Grasshopper. This didn't work for me. However, I reimported a new hatch file into Rhino, refreshed within Human Hatch Table component, and then it reestablished its connection.

Permalink Reply by Giulio Piacentino on August 14, 2014 at 1:04am