Grasshopper - Vorronoi HELP

Hi I'm trying to do the pipes trhough vorronoi but I can not trim them or where they are joined to have a nice clean edge can someone help me?

Attachments:

grasshopper.jpg, 493 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Alexia Ch on October 13, 2016 at 1:03pm

Permalink Reply by Christian Gartland on October 13, 2016 at 1:16pm

I can't really figure out what's happening with your file. I made a sort of workaround by exploding each of the curves, but you get a lot of individual pipes that can't be joined. I think the main issue is how the curved surface creates intersection curves which have a very slight bend to them, so when the piping algorithm attempts to trim the corners of the pipes, it fails, resulting in the small extensions you see.

Attachments:

voronoi fix.gh, 11 KB

Permalink Reply by Alexia Ch on October 13, 2016 at 3:09pm

for now I baked and afterwards I exploded the curves and yes there are a lot of lines. My geometry hat to be an ellipptic paraboloied with vorronoi geometry. Do you have any suggestions?

Permalink Reply by Hyungsoo Kim on October 13, 2016 at 2:59pm

Hi.

If you don't feel uncomfortable with mesh output, then you can use another option.

There are some line thickening tools including this.

Permalink Reply by Alexia Ch on October 13, 2016 at 3:10pm

I do have exoskeletron installed. But I couldn't make it work. I'll try tommorrow your solutions and see if I'm capable of doing it. Could you pls send me the grasshopper file you did? Because With kangaroo that I installed today I couldn't find the remove duplicaded lines but only curves.

Permalink Reply by Hyungsoo Kim on October 13, 2016 at 3:22pm

Install old version(v0.096~0.099?)Kangaroo.

RSS