Grasshopper

algorithmic modeling for Rhino

Grasshopper SKD examples(SimpleGeometry) BUG

Hi everyone,

I copied the codes directly from the Grasshopper SKD examples(SimpleGeometry) to build a GH component,and find that when i set a line with one intersection point  of the circle,but the run result still shows two  intersection points as shown below,it this a bug of the example code?

Views: 339

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on August 11, 2015 at 4:40pm

Circle|Line treats lines as infinite entities. If you want to restrict the intersection to just the visible part of the line, then you should use Curve|Curve.

Permalink Reply by jackieyin on August 11, 2015 at 11:17pm

Thanks David!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service