Grasshopper

algorithmic modeling for Rhino

Grasshopper file slowing down

Hey guys,

I have this boundary component (connected to the cull component) at the end of my definition that takes 22 seconds to process. Could someone please recommend a more efficient way or a better component that I could use that doesn't slow down my file?

The file is uploaded below. Thanks

Views: 296

Attachments:

Replies to This Discussion

Permalink Reply by Perry White on October 30, 2014 at 11:38pm

Also, does a grasshopper file start to slow down after it crashes? Cause I added another component to this definition and it crashed.

Permalink Reply by ng5 Alex on October 31, 2014 at 1:24am

Hello

one workaround is the following,

but you will have to be careful when using this. i believe the srf container component skips the curve planarity check, so its a lot quicker.

cheers

alex

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service