Grasshopper

algorithmic modeling for Rhino

grasshopper display problem

My grasshopper model is clipping when I zoom in close to the objects. And I found when I use zoom extent in rhino, the whole model becomes tiny in the screen, seems there are some other things far away. when I close grasshopper, and use zoom extent again, the whole model showed properly in the screen.

 

Views: 791

Replies to This Discussion

Permalink Reply by horstmith on May 26, 2014 at 9:14am

same problem over here!

is there any solution?

in rhino usually it depends on the cPlane, when objects are to far away from the absolute zero, but how dose it work in grasshopper?

thx

Permalink Reply by Fred Becquelin on May 26, 2014 at 11:02am

It's not the CPlane, it's the viewport's (frustrating) frustrum. I found a way to cure this once in rhino 4 but I forgot!

Permalink Reply by horstmith on May 26, 2014 at 11:59am

thx for your answer, i found a way, don't know why but it worked, i disabled and enabled the whole script, after that the view was correct! :D

Permalink Reply by David Rutten on May 27, 2014 at 5:21am

It might be due to z-buffer bumping. Disable this in the canvas toolbar (rightmost dropdown button).

--

David Rutten

david@mcneel.com

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service