Grasshopper automatically starts in Rhino.

Hi guys,

Since a few days I have a problem with grasshopper automatically starting. It happens right after finishing the first command after starting up Rhino, although it doesn't show the grasshopper command in the command bar.

And Rhino doesn't actually open Grasshopper. It just starts loading all plugins with the green grasshopper screen and afterwards disappears again. It's a bit annoying that whenever I want to start in Rhino and not use Grasshopper it opens and loads.

Does anybody have an idea on what to do to eliminate this problem?

Replies to This Discussion

Permalink Reply by David Rutten on November 16, 2015 at 7:28am

Very strange, you say you have to specifically run a command (any command) before Grasshopper loads?

I assume the Remote Control Panel is not part of the standard layout?

I noticed you have VisualARQ installed. Is that new, or did you update that recently?

Permalink Reply by Siemen on November 16, 2015 at 7:45am

Hi David,

Thanks for your reply.

Yes, if I do nothing, it doesn't start and Remote Control Panel is indeed not part of the standard layout.

Also, VisualARQ is indeed new, if not from when it started happening. Have you heard of any problems with users working with the combination of visualARQ and Grasshopper?

Permalink Reply by Jon Mirtschin on November 17, 2015 at 12:56am

I'm sure it's visualArq causing this.

I'm not sure why, I assume it's something to do with their licensing. Their components only load if the plugin license has been checked. I'm not sure why they launch Grasshopper on Rhino start up as if this is the reason it could be done when Grasshopper is launched by the user.

I'd contact them and ask them to confirm why they do this and if it's possible to disable this if you don't want this behaviour.

Cheers,

Jon

Permalink Reply by Siemen on November 17, 2015 at 1:01am

Thanks for your reply Jon. I'll get in touch with them.

Siemen

Permalink Reply by AJ on June 8, 2016 at 1:34am

actually this could be a nice option.

im not a developer. but i would like to learn how to create this automated *.rvb allowing the command to run and (maybe later this could be in the rhino option to be checked on/off). cheers

RSS