Grasshopper 0.6.0059 available for download

Hi All,

another incremental update, probably the last one for a while. Some minor bugfixes, practically no new functionality.

Download EXE installer

Download ZIP installer

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Replies to This Discussion

Permalink Reply by Danny Boyes on April 28, 2010 at 5:06am

@David or Scott,
should this topic be pinned again after the clean out of the Discussion board and added to the latest Downloads>work-in-progress page

Permalink Reply by Emil Klagenberg on June 14, 2010 at 10:35am

Is it possible to have both v6 and v7 installed at the same time?

Permalink Reply by David Rutten on June 14, 2010 at 1:40pm

Yes, but the installer will remove the older version. Do this:

1. Install 0.6 (and rename Grasshopper.dll to Grasshopper.rhp)
2. Move the entire Grasshopper folder to some other location
3. Install 0.7

To use 0.6:
1. Start Rhino
2. Drag+Drop Grasshopper.rhp into the Rhino window

To use 0.7:
1. Start Rhino
2. Drag+Drop GrasshopperPlugin.rhp into the Rhino window

You only cannot run them both at the same time in the same Rhino.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by taz on June 14, 2010 at 2:31pm

Another popular setup (if you don't feel like drag 'n drop) has recently been:

Use 0.6 with Rhino 5

Use 0.7 with Rhino 4

There are separate plug-in directories.

Permalink Reply by Luis Fraguada on June 14, 2010 at 7:01pm

Taz, I more or less have the same setup above, but, in rhino 4, in plugin manager, I load protect GH as a kind of reminder that I can switch between the two...if I want 0.6.x I load from Rhino 5 dir...if I want 0.7.x I let it keep loading...Kind of a stupid setup, but its growing on me...

Permalink Reply by Miguel Jiménez on July 20, 2010 at 6:56pm

Hi..

Just starting to get familiar with grasshopper, I got a trouble with a very simple loft of two circles. I got the same trouble in previous versions.. anyway.. the baked the circles work fine to loft.

(hope an issue to solve and not my mistake)

THanks a lot.

Attachments:

Permalink Reply by Danny Boyes on July 21, 2010 at 2:33am

Hi Miguel,

The problem you're facing is a mismatch with the tree structure of both sources. The Loft component will only loft curves that are on the same level of branches (tree structure).
In the image below you can see the tree structure with the Param Viewer Component and the use of the Simplify Component to make them similar.

Permalink Reply by Miguel Jiménez on July 21, 2010 at 7:46am

Thanks a lot.. It works now..

:)

Permalink Reply by dedier Planinc on August 15, 2010 at 12:31pm

Hi I m new in this thing so dont laugh :D but yeah When I entre my plug in manager there is just
grasshopper.DLL file??? and when try to install there is notification saying that it is designed for Rhino 4.0 witch I have tho?? is it maybe not the latest version or some other problem????
thanks

Permalink Reply by mahditabatabaie on August 26, 2010 at 7:11am