grashopher 3d design

Replies to This Discussion

Permalink Reply by JS on December 1, 2013 at 8:00pm

Hi I tried my best and this should at least get you started. I couldn't figure out a few things though.

There are 25 top edges with 3 points each and I wanted to randomly select one point from each path to move down then rejoin them again. Right now it is not randomized.

Also I needed to scale the top triangles so that as the height increases the size decreases.

Anyway, hopefully with this, you or someone else can keep working with it.

Attachments:

• argar.gh, 15 KB

Permalink Reply by shafaitemahmud hridoy on December 4, 2013 at 3:08pm

hey thnx a lot ,, i managed to do that,,thnx a lot man... 

Attachments:

• 3d morfing _HRIDOY.gh, 13 KB