Gradient triangulation pattern on triangle surface

Replies to This Discussion

Permalink Reply by karelovic on May 25, 2016 at 2:36pm

Thanks a lot guys! It is very helpful for me ;)

Permalink Reply by karelovic on May 26, 2016 at 10:46am

Do you know how to manage the same visual as your picture on my triangle surfaces?

Because the frame is pulled towards one angle of the triangle surfaces every times.

I don't know how to avoid that.

: /

Attachments:

• PRISME.3dm, 3.2 MB
• TrianglePatternOnSrf03.gh, 15 KB

Permalink Reply by Hyungsoo Kim on May 26, 2016 at 11:00am

Don't apply the second definition to your rhino model.

"copy Trim" only works for you when your target surface has the same U&V domain order.

That's why I've converted your triangle surface into mesh using weaverbird plug-in.

So, the seccond definition is not for your model. It works well with rectangular surface.

Permalink Reply by karelovic on May 26, 2016 at 1:02pm

Ok i will try. Thank you ;)

Permalink Reply by karelovic on May 26, 2016 at 4:20pm

It works, but i still don't know how to do borders on triangle surfaces and i can't bake one complete surface. All triangle surfaces are divided by the pattern on my file here attached. I tried several joining meshs or breps, but it doesnt work.

• ‹ Previous
• 1
• 2
• Next ›
• Page