Grasshopper

algorithmic modeling for Rhino

Gradient colour by extrusion

Hi everyone,

I am finding it difficult to colour these extruded circles by their height.  I have just extruded them in rhino not in grasshopper and would really appreciate some help.  I assume i have to divide them along the Z plane but I don't know the full script to achieve this.

Thanks

James

Views: 1916

Replies to This Discussion

Permalink Reply by James Williamson on January 6, 2013 at 9:48pm

Does anyone have any ideas?  I really don't know this programme very well!

J

Permalink Reply by Michael Pryor on January 6, 2013 at 10:19pm

just set your breps in the brep param. 

Permalink Reply by Michael Pryor on January 6, 2013 at 10:20pm

the file

Attachments:
Permalink Reply by Rodrigo Medina on January 6, 2013 at 10:29pm

Hello, why don't you try to use the bounding box component , you could store each cylinder in a box  then you can use the box components   component and extract the Z  value.

You will get as an output a domain you need t use the domain components component to extract the height number which you can use to reference it to an rgb value 

Hope that helps

Permalink Reply by James Williamson on January 6, 2013 at 10:58pm

Thanks for the help guys, I have a lot to learn!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service