Grasshopper

algorithmic modeling for Rhino

got extra meshes while turning brep to mesh

In the example file attached, I try to turn a group of 259 brep surfaces into one single mesh with 259 faces.

However, I got the following problems:

1. there are two faces in some of the meshes converted from a single brep

2. there are more than 259 faces in the single mesh created using the workflow show below.

May I ask what important step I may have missed here?

Thank you!

Views: 775

Attachments:

Replies to This Discussion

Permalink Reply by Grasshope on October 16, 2016 at 9:19am

The most frustrating thing is that depending on the proportion of the brep surfaces, the same workflow can produce a mesh with different number of faces:

Attachments:
Permalink Reply by Jacob Peel on October 16, 2016 at 10:25pm

I am not sure why there are extra vertices in some of the converted meshes without knowing more about the referenced brep, but a clean rebuild of the input brep will fix the problem.

Attachments:
Permalink Reply by Grasshope on October 17, 2016 at 1:00am

Thanks, Jacob. Actually, the breps are created parametrically using GH native components.

I'm not sure what is causing this issue...

Hope you can kindly advise.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service