Go home quadtree you are drunk. This guy disobeys my house tree rules...

Replies to This Discussion

Permalink Reply by ng5 Alex on May 3, 2016 at 6:25pm

You can do the following

best

alex

Attachments:

• quadtreeflatterino1.gh, 28 KB

Permalink Reply by Jonas Blazinskas on May 3, 2016 at 6:44pm

Just found the same solution on an older post, but what would happen if I have planes not only on the z axis? This would not work right? Or could I just plug all the x y z? I don't think it would be that easy it never is :D. 

Permalink Reply by ng5 Alex on May 3, 2016 at 6:57pm

you could use plane fit component to your initial points, and test the distances of the resulting planes against the area center of the quad tree polylines. the ones with distance ~0 from each plane belong together.

best

alex

Permalink Reply by Jonas Blazinskas on May 3, 2016 at 7:02pm

Sorry, which component do I use to test the distance? 

Permalink Reply by ng5 Alex on May 3, 2016 at 7:04pm

plane closest point

Permalink Reply by Jonas Blazinskas on May 3, 2016 at 7:18pm

Missing something obvious here? The only thing I could think of is to somehow get 9 lists of same curves...wait do I just graft it?

Edit: nope that doesn't work, match tree maybe?

Attachments:

• planerino.gh, 43 KB

Permalink Reply by Jonas Blazinskas on May 3, 2016 at 7:33pm

oh god they dont align by 0.0004 

Permalink Reply by Jonas Blazinskas on May 3, 2016 at 7:50pm

So plugin the plane that i get from points back into quadtree to align them together seemed to work buuuuut, the numbers don't add up at the end still. Less resulting 0 distances than there is centroids?... Yeah 3 planes are still not aligning

Attachments:

• planerino2.gh, 72 KB

Permalink Reply by ng5 Alex on May 3, 2016 at 8:02pm

please study data trees and the forum.

you will find all the answers you need.

the distances are not 0 due to the rounding of floating numbers. in such cases you use similarity component and not equality.

there are many methods to sort these curves in a tree. unfortunately its too late here for me to suggest something else.

ps try not to work so far from 0,0,0. this introduces problems in rhino.