GIll Surface

HI Guys,

I have created an algorithm for GIll Surface but just the end part which is for lofting curves together does not work I do appreciate if someone can take a quick look, must be an easy trick to get it done.

Attachments:

gills para.gh, 11 KB

Replies to This Discussion

Permalink Reply by deli dumrul on June 6, 2016 at 1:27pm

cull index is not working, i gave "0" value for indices, and it's doing something now, not sure if it's what u're looking for. attached.

Attachments:

gillspara.gh, 18 KB

Permalink Reply by faya on June 7, 2016 at 8:23am

THank you Deli but no actually looking for Gill surface result but thanks for your reply.

Permalink Reply by Hyungsoo Kim on June 6, 2016 at 2:00pm

Something like this? With this, you can get more control of gill opening.

Attachments:

gillspara_re.gh, 15 KB

Permalink Reply by faya on June 7, 2016 at 8:11am

Thank you Dear Hyungsoo,

I believe this is what I am looking for, Thank you.

Permalink Reply by faya on June 17, 2016 at 9:42am

Dear Hyungsoo,

I was looking to apply this algorithm on a vertical wall of my project which is attached. Also I wanted it to be like the attached photo which is an image from PARAGRASS books.

I do appreciate your help for its application. Also, one more thing can they get scaled following parabola curve as I ve shown on the facade.

Thank you

Permalink Reply by faya on June 17, 2016 at 10:16am

the file attached

Permalink Reply by faya on June 17, 2016 at 10:28am

the file attached

Permalink Reply by Hyungsoo Kim on June 17, 2016 at 1:25pm

Where is your file?

Permalink Reply by Hyungsoo Kim on June 17, 2016 at 1:28pm

Anyway, hereby I attached my two cents. Check it out. Best.

Attachments: