GIll Surface

HI Guys,

I have created an algorithm for GIll Surface but just the end part which is for lofting curves together does not work I do appreciate if someone can take a quick look, must be an easy trick to get it done.

Attachments:

gills para.gh, 11 KB

Replies to This Discussion

Permalink Reply by faya on June 19, 2016 at 3:53am

Thank you Hyungsoo, Do you think studying Algorithms and programming can help in better scripting in Grasshopper?

Permalink Reply by faya on September 30, 2016 at 10:30am

Hi Hyungsoo,

the model you helped me for Gill facade while ago, I also want to have gill on the other facade slightly different with the other one.

I used my algorithem and created something but it isnt nice and exactly as I m looking, I do appreciate if you take a look and see if there is way to make it .

thank you so much

Permalink Reply by peter fotiadis on June 18, 2016 at 1:33am

See this attached as well (a very old def: now all the pasta is replaced by a single C#)

Note: an abstract concept on a facade and a real-life facade of that type ... are VERY different animals. Don't follow that path unless you can FULLY master the details (fasteners, adjustment system, panel joins, faceting policy, nuts, bolts, cats, dogs etc etc). And of course is the cleaning "trivial" matter (facades require that ... "occasionally").

Attachments:

gills5.gh, 169 KB

Permalink Reply by faya on June 19, 2016 at 3:50am

Thank you Peter! interesting but hard to manipulate , I was looking to scale them following parabola curve, as it is shown in my model, if not easy then just I use it in other ways.

Permalink Reply by Michael Pryor on September 30, 2016 at 11:33am