Grasshopper

algorithmic modeling for Rhino

Getting a Volume from created surfaces

 

Dear All

 

I intend to make a series of surfaces (e.g. cylinder with top and bottom cover) which i need to calculate the inside volume. However, the surfaces are mentioned to be not closed. Can anyone help me figure it out.

 

The needed final outcome is to get the volume of the created geometry.

 

Many Thanks in advance

 

Tony

 

 

 

Views: 2092

Attachments:

Replies to This Discussion

Permalink Reply by Jon Mirtschin on September 12, 2012 at 10:48pm

Hi Tony, 

Try the CAP component which will help if openings have planar edges.

Refer attached.

Cheers,

Jon

Attachments:
Permalink Reply by LionOfLowe on September 13, 2012 at 8:41am

Hi Jon

Many Thanks!

More Power

Tony

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service