Geometry pipeline conflict with rhino display

Hi everyone !

Not sure if this is an actual error or done by design...

I have three geometry pipeline components importing surfaces and curve. When these are active, I can't display any Rhino geometry unless I "don't preview any geometry".

I tried with any other surfaces and curves imported conventionnally and this doesn't happen.

Funniest part is, I also tried to internalize pipeline exported data and desactivating the pipeline component, same problem BUT ... I then copied internalized component and desactivated the first internalized one : rhino and grasshopper now display at the same time...

Any thoughts ?

Attachments:

PipelineDisplayIssue.jpg, 167 KB

Replies to This Discussion

Permalink Reply by David Rutten on July 24, 2013 at 2:39am

It certainly sounds like a bug. Can you post 3dm and gh files I need to reproduce this?

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by Sylvain Usai on July 24, 2013 at 3:08am

Here is more... The problem seems to comes form an evaluate surface component, occurs if activated (suddenly, it sound more user related... :s ).

Attachments:

1307-24_UniInput.3dm, 243 KB
1307-24_UniInput_01-ImportAndSortInputGeom.gh, 116 KB

Permalink Reply by Sylvain Usai on July 24, 2013 at 3:33am

... Definitely user relative I think... I forgot to reparam one of the surfaces (surface CP S input), I think evaluate surface output was then too far from the rhino origin causing troubles in display...

If so, I am confuse!

RSS