Grasshopper

algorithmic modeling for Rhino

Geodesic dome extrusion trim

Hey guys. 

I'm new to grasshopper. I've created a geodesic dome in grasshopper through the points which define the centre of each hexagon. I then used the facet dome to create the hexadome. I then extruded the surfaces a defined distance to the centre of the sphere. But I cant get ride of the over lapping of the solids on the inner side of the dome. I need the vertices of on the inner side of the dome to align to each other. Also is there a way to locate and group similar hexagons, or find a pattern in the variation of the sized of the hexagon. I've attached the rhino and grasshopper file

Views: 3196

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on October 31, 2011 at 7:23am

It is not possible to save files in older versions.

Permalink Reply by Lelouch on November 16, 2015 at 11:14am

How did you generate the point grid for this definition?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service