GenCumSkyResult - Runtime error?

Hi Mostapha,

I am getting an error when I run GenCumskyResult. It says " Runtime error: too many values to unpack..." please see the image below:

Do you have any idea to solve this problem? Please let me know.

Thanks, Won Hee

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on February 17, 2014 at 10:27pm

Hi Won,

I would say that you need to update all Ladybug components. As you see today Mostapha & Co released the new version (0.54). In your picture you see that the LB_Ladybug is dated Feb 16 and the GenSky is Jan 3.

I'm pretty sure this will do for you. Follow the update instructions in the main LB page.

-A.

Permalink Reply by Mostapha Sadeghipour Roudsari on February 17, 2014 at 10:30pm

Ha... You beat me by less than a minute! :)

Permalink Reply by WON HEE KO on February 18, 2014 at 1:28pm

Thanks, it was the prob. :)

Permalink Reply by Mostapha Sadeghipour Roudsari on February 17, 2014 at 10:29pm

Hi Won Hee Ko,

As far as I can see you are using an old gencumsky component (VER 0.0.35) with the new Ladybug version (VER 0.0.54). That's why it gives you this error. Remove the old component and use the new one and it should be all fine.

Hope it helps,

Mostapha

PS: Where did you find the component from the old version? Hopefully not from the new release or the example files?

Permalink Reply by WON HEE KO on February 18, 2014 at 11:40am

Thanks, it had it in my previous Ladybug - it was not from the new release/ example files :)

RSS