Grasshopper

algorithmic modeling for Rhino

function equation and extrude component

Hey guys,

 

I am trying to make a series of 9 circular floors that as they go up to the middle floor the diameter increases and from the middle to the top decreases to the original position.

 

I have used a function y= (1/10)*x²+(x+1) in order to have a concave down parabola. but the results don't seem to be the expected ones.

 

Also the extrude commant failed to receive data.

 

Can some have a look at it and give me a possible solution?

 

Thank you Natasa

Views: 805

Attachments:

Replies to This Discussion

Permalink Reply by Caglar on November 11, 2011 at 6:00am

You didn't specify an extrusion vector. I changed your definition a bit so the top decreases back to original position if it's what you wanted.

Attachments:
Permalink Reply by Natasa on November 11, 2011 at 6:08am

Thanks a lot :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service