Grasshopper

algorithmic modeling for Rhino

Flow along surface

Hi. I have been playing around with a simple definition from another thread on morphing planar curves/patterns on to a surface. In this definition the planar pattern has to be placed in the XY plane, if they are not the morphed surface is wrong. I have been trying a bit with changing the u,v intervals. The XForm.Surfmorph has i w mapping input, but i am not sure how to get this?
I don't think that I completely understands what is going on with the bounding box....

Best regards Rasmus

Views: 30984

Attachments:

Replies to This Discussion

Permalink Reply by Simeon Simeonov on May 19, 2012 at 4:21pm

Thanks  a lot. This is very helpful

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service