Floor Plates of a Brep

Replies to This Discussion

Permalink Reply by GW on April 17, 2013 at 10:30am

Try something like this, using X-Y planes set at specific height intervals to intersect the brep for floor planes and ceiling planes. You can then close the edges between the two if you like. There are various ways you can define the plane locations. The method I show in this image is probably a little more complex than necessary, but I extracted it from a much more involved building form generation definition where it made sense.

Attachments:

• floorplanes.jpg, 110 KB

Permalink Reply by Surge Troost on April 17, 2013 at 1:20pm

Thanks worked nicely!