Grasshopper

algorithmic modeling for Rhino

Flipped / reversed normals

Hi, I had just started to learn Grasshopper this weekend.

And I've tried some definitions, some of them have the same problem, the normals seems to be flipped. It's noticed when the Weavebird's Mesh Thicken or even using offset surface is applied, some of them went inward other outward.

Anyone knows a way to make them have the same direction? Maybe comparing one cell with the side one and making a normal average.

Thank you for your attention!

Views: 490

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on July 10, 2017 at 4:18pm

Hi.

Take a look at the attachment.

Attachments:
Permalink Reply by Hyungsoo Kim on July 11, 2017 at 1:51am

Add WB - mesh smoothing..

Attachments:
Permalink Reply by Guilherme Bera on July 17, 2017 at 10:33am

uuh, there we go!! Sorry for didn't reply before, I was trying to go further with you 1st answer. I had tried to find a way to identify the face orientation to then flip it, but I have an insignificant advance.

And I just found this discussion http://www.grasshopper3d.com/forum/topics/normal-directionagain-sor..., however my small knowledge in icons couldn't help to reproduce the full definition.

Thanks for your attention!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service