algorithmic modeling for Rhino
Tags:
This is truly helpful, Thanks for this.
But may I ask you a question, what if you want to make the inverse surfaces of what srfgrid component creates when you bake any of the 3 in the file??? i.e in curve set three when you bake the last component it gives you a 10 points surface and then leaves a 4 points one, what if I want to make a 4 points surface and then leave the space of a 10 points one?
Hi Sherif
a more flexible way.
Renzo
interesting one, thanks for that too.
Renzo:
May I ask you a very dumb question, Why you write {A;B}(i),
with "i" as data inside the tree?
I don´t know nothing about programming or else and I´m trying very hard to understand data trees.
Thanks for the previous files, now I´m finally getting some of its logic.
Best!
Thanks All,
These are helpful.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by