Grasshopper

algorithmic modeling for Rhino

Fit a surface to edge curves with Galapagos

Hi Galapagossers

I wondered how Galapagos Solver could be helpful to the attached built up definition.

A surface (as shown in the definition) that shall be pulled as good as possible to given edge-curves. (So the maximum deviation will return a minimum achievable lenght)

thanks for any hints in advance,

angelos

Views: 947

Attachments:

Replies to This Discussion

Permalink Reply by ANGELOS on December 6, 2011 at 3:16am

Hi all,

sure the solver works fine and gives the expected output .

How could I manage the resulting surface be less kinky?

angelos

Permalink Reply by ANGELOS on December 7, 2011 at 1:35am

As in previous forum articles said, ( I sould have been more attentively), taking massaddition as fitnessfunction works satisfying here!

End of monologue - Thanks for all good discussion material to research.

Angelos

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service