Grasshopper

algorithmic modeling for Rhino

finding the most common number in a list

Hi all,

Complete newbie here...

The issue:

I have built a model in grasshopper, but some of the panel centroids are .1 - 1mm out of plane in the Z direction. I would like to move these panels back into plane.

I would like to extract the most common number from a list, in order to shift the incorrect panels to the most common plane.

What is the easiest method of extracting the most common number from a list?

Apologies if this is a simplistic question.

Views: 1761

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 19, 2017 at 2:48am

Hi.

Check this out.

Attachments:
Permalink Reply by Alec Litchfield on April 19, 2017 at 3:08am

perfect! worked a treat!

Thank you very much!

Permalink Reply by David Rutten on April 19, 2017 at 3:39am

You may also get a useful answer using just the Truncate component. But you'll have to tweak the truncation factor to suit your particular number distribution.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service