Fillet (parameter) component with list of parameters

Hi,

If I want to fillet a multi-segment curve using the Fillet (parameter) tool, the problem is when I feed it a flat list of parameters and the curve, I get as many different solutions as parameters input - each curve output has just one of the fillets...

Is there a solution for this that I haven't found (likely)... or if not, can a "create one curve per input curve" toggle be added to the component?

Thx,

--Mitch

Replies to This Discussion

Permalink Reply by Danny Boyes on February 23, 2012 at 4:00am

I think David made this component to overcome the issue with the other 2 Fillet Components that would sometimes not allow the correct size of Arc, if memory serves me, it was an ad-hoc component to deal with only one fillet in a pair of curves.

Until David returns you can use this definition, or rather adapt it to suit, which hopefully identifies which curves you want to keep and joins them up.

Attachments:

ReJoiningFillets.gh, 24 KB

Permalink Reply by Pieter Segeren on February 23, 2012 at 12:37pm

Hi Mitch, I had the same question some time ago, maybe you can find a solution you like in this thread: http://www.grasshopper3d.com/forum/topics/filleting-polyline-t-ques...

Permalink Reply by Pieter Segeren on February 26, 2012 at 12:17pm

Hi Mitch, I got something I'd like you to try. I made a Fillet Polyline User Object that takes a list of radii, one for each corner. Should work on non planar polylines too.
(You can try the example first, if you like it: The UO will appear in the Curve > Utils tab.)

Attachments: