Grasshopper

algorithmic modeling for Rhino

Fillet Lofted Surface

Hi there,

I am creating a 3D object using the UV lines of a lofted curves where I have scaled the rectangles between each UV lines.  I can fillet the corners of the of these rectangles when the curves that I have lofted are straight, but once I make make them curved the fillet does not work anymore.  

How can I get the fillet to work on a curved surface?

Thank you.

Views: 2733

Attachments:

Replies to This Discussion

Permalink Reply by Birk Binnard on March 25, 2017 at 12:22am

Try this component - I found it a while ago and it usually works pretty well for me. You just have to attach your 2 surfaces and set the fillet radius. If the fillet goes the wrong way - which happens frequently - switch one of both of the Boolean variables.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service