Fillet limit?

Replies to This Discussion

Permalink Reply by Danny Boyes on April 18, 2012 at 3:00am

there is a limit with this component which is for "filleting the sharp corners of a curve". The main issue here is cornerS if you have more than one corner to fillet each segment of the curve has to be able to cope with a fillet at the start and end of a segment therefore anything greater than half the length is going to fail.

If you want to over come this then there is a fillet at a parameter component where you specify the parameter of the corner you want this also come s with its only limitations though 

Permalink Reply by Hannes Löschke on April 18, 2012 at 3:07am

Fillet will only work until the fillet hits the middle of one line. This also applies to Rhino fillets

Permalink Reply by Anja on April 18, 2012 at 3:11am

Ah, thanks, fillet at parameter (0) solves the problem.

I already figured it looked a lot like the fillet stopped at half the length. Know I understand why ;)