Grasshopper

algorithmic modeling for Rhino

Hello everybody!

*attention: noob alert* :)

I've been trying to generate an ordinary flat golden spiral, but with no success. It seems to me it should be simple though...

I've found this discussion: http://www.grasshopper3d.com/forum/topics/fibonacci-square-sequence

While it's a nice solution, it looks like it could be stripped down a little, couldn't it?

I also see "receivers" there, so it might have been done a while ago, maybe using updated components the solution could be simpler?

Thanks a lot!

LUCAS

Views: 19907

Replies to This Discussion

Spiral is ugly at the beginning though.

Thanks a lot for your time Systemiq!

You say the beginning is ugly because it's a degree 3 interpolation, right?

But if you take a middle section, discarding the beginning and the end, it looks very accurate.

I'll see if I am able to improve it a bit.

Regards

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service