algorithmic modeling for Rhino
Hello everybody!
*attention: noob alert* :)
I've been trying to generate an ordinary flat golden spiral, but with no success. It seems to me it should be simple though...
I've found this discussion: http://www.grasshopper3d.com/forum/topics/fibonacci-square-sequence
While it's a nice solution, it looks like it could be stripped down a little, couldn't it?
I also see "receivers" there, so it might have been done a while ago, maybe using updated components the solution could be simpler?
Thanks a lot!
LUCAS
Tags:
Thanks a lot for your time Systemiq!
You say the beginning is ugly because it's a degree 3 interpolation, right?
But if you take a middle section, discarding the beginning and the end, it looks very accurate.
I'll see if I am able to improve it a bit.
Regards
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by