FADING PATTERN'S HEIGHT TOWARDS EDGE

Hi friends,

I prepared a definition which creates a topography shape with an upside down "U" shape section(as you see in the attached file). DO you know how I can fade the height towards the attraction boundary (cyan color curve)? I want the height amount decrease as it reaches the boundary. Thank you kind guys in advance for your time and consideration.

Attachments:

pattern.3dm, 306 KB
pattern.gh, 11 KB

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on September 8, 2015 at 11:56am

Do you want something like this. I took yesterday files. You can adjust attractor with mapper.

Attachments:

pattern_topography_LD.gh, 25 KB

Permalink Reply by Moh Mom on September 8, 2015 at 3:49pm

I appreciate your help buddy. but, it is not what I want unfortunately... Did you see the section of the pattern? something like "n". I want this section to become flat as it reaches the cyan boundrary. not the heigh of the whole curves.

Permalink Reply by Moh Mom on September 8, 2015 at 3:52pm

Like this

Attachments:

IMG_4497.JPG, 35 KB

Permalink Reply by Laurent DELRIEU on September 8, 2015 at 11:55pm

Hello
I hope you tried to understand what I did you have almost everything
Flat means constant height so if your attractor curve is at constant height il will solve one problem
If you want all curves to be flat outside the attractor test each point of the curves if they are inside or outside
If outside put z to 0
Good luck Einstein

RSS