Grasshopper

algorithmic modeling for Rhino

Extruding Hex panels

Hello, world! Happy to become a member of GH community!

Help me please to solve an issue:

I need to extrude hexagon cells, made with Lunchbox, to an attractor point and cut in at some distance from cells. I put perpendicular planes at the end of each line which are going from centers of cells. But on the nearest to attractor point center point of hex there is a problem, this point doesn't move as others. I can't understand where the mistake was taken. 

Views: 1477

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 15, 2016 at 7:21am

Hi.

It's because your lunchbox attractor component's domain has been set up from 0 to 1,

so, 0 value multiply some number returns 0.  To avoid this, you should reset the start value of domain above 0.

Attachments:
Permalink Reply by Nikita Polkovnikov on April 15, 2016 at 9:03am

Thanks a lot! You gave me the time to finish that working day on a good note! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service