Grasshopper

algorithmic modeling for Rhino

ExtrudeFace?

Hi all,

 

I'm trying to simulate the ExtrudeFace command.  I have a closed Brep > Explode component.  Could someone help me understand how to cull the F(aces) output to grab the faces I need?

 

tia,

 

dh

Views: 514

Replies to This Discussion

Permalink Reply by Declan Halpin on April 4, 2011 at 10:06am
In this simple example it is just a cube, where the two extracted srfs are adjacent.
Permalink Reply by Danny Boyes on April 4, 2011 at 10:20am
Of course this only works for a cube. But it might get you thinking.
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service