Extrude from a grey scale

Replies to This Discussion

Permalink Reply by Florian Frank on January 8, 2013 at 11:01am

Ciao Andrea,

Search the forum for the Image Sampler there are enough examples...the command extrude doesn't exist for mesh, but i can give you some custom codes that do enable this.

But first try to understand the image sampler and what it does and make an example where you explain a little bit what you wan't to achieve.

Cheers FF

Permalink Reply by Felipe Romero on January 8, 2013 at 8:03pm

This is a very simple example that works whit a mesh, I also think that you should look more about Image Sampler

http://www.grasshopper3d.com/forum/topics/surface-from-points-using...