Grasshopper

algorithmic modeling for Rhino

Extrude both directions

is it possible in the next release to add a Boolean to extrude component to switch between extrude and extrude both sides, opposed to giving extrude 2 opposite vectors then unioning. Just seems more convenient.

Views: 1518

Replies to This Discussion

Permalink Reply by Andres Gonzalez on November 1, 2011 at 2:08pm

Nice idea.

Permalink Reply by Duncan W on July 22, 2013 at 4:43pm

+1

Permalink Reply by Michael Pryor on July 22, 2013 at 5:11pm
Maybe an extrude options component. Like loft options.
Permalink Reply by Duncan W on July 23, 2013 at 10:36am

I like this.

Also please make it a single surface, not two extruded left/right from centre.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service