Grasshopper

algorithmic modeling for Rhino

extract drawing from grasshopper form

I have made this form by a grasshopper definition + t splin plugin but now i have a problem getting any drawing from it by make 2d order it doesn't even select it could someone helping me know what is the problem?

Views: 440

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on May 17, 2017 at 9:23am

If it's just a pure Make2D in Rhino5 question, you're better off asking on the discourse forum. I do not recall if Make2D in Rhino5 supported meshes or not. Is your geometry a mesh?

Permalink Reply by Richard Schaffranek on May 17, 2017 at 9:35am

Did you bake it?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service