Example Voronoi, SrfSplit split surface with big tolerance.

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on May 19, 2011 at 6:13am

After a few experimentations, it looks like the Mapsurf component is faulty.

After having projected the mapped curves on surface, it looks like it works lot better.

So the fix would be: Mapsurf like before, then decide a projection direction (by example the line between the centers of your inside and outside curves), project the mapped curve on surface, use these curves to split and loft.

Permalink Reply by Yoann Mescam (Systemiq) on May 19, 2011 at 6:36am

The middle loft profile curve should be fixed too, or the loft may seem weird.

Permalink Reply by Atsuo Nakajima on May 19, 2011 at 10:25pm

Hi, 

Thank you. I will try with using project component and upload fixed GH definition later.

Permalink Reply by Atsuo Nakajima on May 20, 2011 at 3:25am

Using project component looks good, it has no join problems.

However some modeling cannot cover by Grasshopper, complex use with Rhino and GH is practical way.

 

Attachments:

• VoronoiExample110520.ghx, 1.1 MB
• VoronoiExample110520.3dm, 3.9 MB