Grasshopper

algorithmic modeling for Rhino

I was learning this software alone. And I am testing a 2 point girder, like it in the attach.
I cannot change the load and load location.
Please tell me how to set the load and location of it.
Thank you so much!

Views: 349

Attachments:

Replies to This Discussion

I am  not sure how your model is built, but in general if you want to apply a point load you should have a node at the point of application [that means that you should split the frame element at the point where the load is]. Loads are applied to nodes, and nodes are created at the endpoints of line segments or on the vertices of meshes.

Thank you very much for your reply! Now I understand that I should break the line

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service