Grasshopper

algorithmic modeling for Rhino

Efficient method for meshing a circle

Hey guys

The other day I needed to obtain a clean mesh result from a circle, as shown below.

Mesh Brep gives an awful result and Mesh Surface won't do it properly either, the simplest (fewest component) method I could do it with at the time was something like this:

Surely there is a far simpler method to doing it than I've come up with. Anyone have any ideas?

Views: 1827

Replies to This Discussion

Permalink Reply by David Rutten on May 16, 2015 at 6:07am

Use Delaunay.

Permalink Reply by Daniel Christev on May 16, 2015 at 8:55pm

*facepalm*

I tried that at first but I didn't set it to the correct CPlane. Thanks David!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service