Grasshopper

algorithmic modeling for Rhino

Easy Absolute Radius

Hello,

I need to create circles that have the variable radius to be proportional from the value of the mean curvature by putting a function.

In some referance it says put f(x) a value like abs(x*20). 

Am I doing something wrong that I could not figure it out. Sometimes the referances use an older version of grasshopper and the commands could be replaced with an other.

Waiting for my easiest problem.. :) 

Views: 314

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on January 30, 2015 at 4:38am

Hello Bora,

What is your question?

The circles are created, they just have a very small radius (instead of 20 you should use something like 1000 or, even better, a variable).

There are a few ways to achieve what you want. Here are three:

Attachments:
Permalink Reply by Bora Doker on January 30, 2015 at 1:11pm

Hey Nikos,

I apologize, I thought i was doing something wrong but it was the limits.

Thank you very much with the other solutions too..

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service