Dynamic Explode Tree

Hi everybody ;

I'm new on Grasshopper and I have some trouble with the Explode Tree component.

The number of branches of my tree can change, and I would like my Explode Tree component automatically adapts to this number, with the good number of outputs, without clicking every times on "Match Outputs".

Is it possible ?

Thanks a lot.

Replies to This Discussion

Permalink Reply by phillip on May 30, 2012 at 3:52am

You can use the treebranch.

Permalink Reply by Rhydro on May 30, 2012 at 8:29am

Thank you for answering so quickly !

I'm not sure I understand your solution, I'm trying to figure out if it really does what I wanted to in the first place.

But I think I've found an other solution to my problem, not requiring a dynamic explode tree component.

Anyway, thanks a lot !

Permalink Reply by Dongyeop Lee on July 7, 2016 at 7:39am

I've run into the same question you had a long time ago... It might be too late to ask this question, but do you have a solution to explode data trees dynamically? As shown in the attached image, I'm wondering if there is a way to make a correct number of output nodes matching the number of branches in the input data automatically.

Thank you!

Attachments: