duplicating sets of inputs....

I have a component whose output is plugged into a bunch of other components inputs.

I have a different component (outputting the same type of data) that I would like to plug into the same set of components' inputs that the first component is plugged into...is there a way to do this without having to individually plug in everything again?

thanks for the help!!

Replies to This Discussion

Permalink Reply by Ching on April 8, 2012 at 4:24pm

I think you can plug a generic Params component (e.g. Points) to your target components, and plug the input into that Params and after that you can switch the input by just replugging one component. But you need to replug everything once too set it up. Not sure if there's another way.

Permalink Reply by John on April 9, 2012 at 12:40am

Thanks, Ching....yeah, that's what I've been doing...but I'm wondering if there's a way to avoid that initial step...I have a long definition and have to do some brain surgery on it, and wanted to quickly reroute some of the paths. thanks for the tip though!

Permalink Reply by Hannes Löschke on April 9, 2012 at 2:56am

You can reroute all connected wires by holding SHIFT and CTRL. So you don't need to manually reconnect all those wires. Is that what you mean by "initial step"?

Permalink Reply by John on April 9, 2012 at 3:00am

yes! That's exactly what I was looking for, thanks!

RSS