Duplicated Lines - Curves

Replies to This Discussion

Permalink Reply by David Rutten on July 10, 2014 at 9:39am

Lines are straight pieces of curve. If you plug curves into a Line parameter, then only those curves that can be represented as straight lines will convert, for the remainder you'll get an error message like you just saw.

You can choose to ignore the error if you're okay with the non-linear curves not being checked for coincidence.

--

David Rutten

david@mcneel.com

Permalink Reply by ng5 Alex on July 10, 2014 at 9:46am

you can try this one too.

http://www.grasshopper3d.com/profiles/blogs/remove-curve-duplicates

Permalink Reply by Arend on July 10, 2014 at 9:48am

Is the "SelDup" command in rhino not an option? (Remove duplicates after baking?)

Permalink Reply by Mohanned Iskanderani on July 10, 2014 at 11:17am

It is, it will just make life alot easier if done in Grasshopper before hand