Draped surface grid problem.

Replies to This Discussion

Permalink Reply by Vicente Soler on March 14, 2012 at 4:32pm

You can't set an exact distance apart from each other but you can use the surface.analysis.dimensions component to get an aproximate length in the u and v directions. You can then divide the u and v lengths by the desired separation to get the number of subdivisions. But this is only an aproximation and will only be useful is the surface is not very curvy.

 

Btw, run the _shrinktrimmedsrf component on the surface. You are generating 499 values for each row when only ~40 points are being displayed. The rest are null values that are used so that grid order is mantained when the surface is trimmed.

Permalink Reply by Shkattii on March 14, 2012 at 5:25pm

Thank you so much for your help.

If i want to apply circles to the points on the surface, how do i make them so that they are flowing  over the surface? After that i want to project lines from the points in the Z direction, how could i do it so that the lines has a range of heights from the points? 

Permalink Reply by Vicente Soler on March 14, 2012 at 5:56pm

Use the "surface frames" component to generate planes instead of points and use those planes to place the circles. Use the unit z component and the line SDL component to generate the lines.

 

You are asking very basic questions. I'm sure you can find examples of this in the "getting started" section under tutorials. I suggest you look through the example files and do a few tutorials and if you then have any specific questions come back to the forums.

Permalink Reply by Shkattii on March 14, 2012 at 9:15pm

Is there a way to count the number of points only within the surface? and not the points falling off the boundary of the surface? Thanks