dividing a surface into smaller ones

Replies to This Discussion

Permalink Reply by Yasser Hafizs on June 7, 2013 at 1:23pm

Hi Noam,

Hope this help you

Permalink Reply by Noam Naveh on June 7, 2013 at 2:05pm

hello Yasser,

thanks - thats a big step for me

maybe you could attend this one:

how do i distinguish between a bigger U or V?

that is, how do i match the "shortest one" to the low value between U and V?

i think this requires a IF THEN condition, but i couldnt really figure out how to do that.

thanks again!

Permalink Reply by Yasser Hafizs on June 7, 2013 at 2:38pm

Use stream filter after the conditional (false = 0, true = 1)

Permalink Reply by Noam Naveh on June 7, 2013 at 3:07pm

still no go:

u and v still need to be change depending on the surface's direction.

im trying to fix is to that the low result will always find its way to the shorter measurement between U and V.

currently still needs manual switching (or surface 90 degree rotating)

Permalink Reply by Yasser Hafizs on June 7, 2013 at 3:35pm

I think you have reversed surface, try to dir > SwapUV the surface in rhino or use custom component from David. It should been released in latest version, I couldn't find out and also flip surface component still not work in latest GH version.

EDIT: not flip, but dir > swapUV