Grasshopper

algorithmic modeling for Rhino

Dividing a Lofted Surface from Curves

I have lofted a surface from offset curves, now I want to divide that entire surface (to make vertical lines) in the V direction, but it wont allow me to do it.

It seems to be dividing the original curves not the surface....

 any ideas?

Thanks

Views: 237

Attachments:

Replies to This Discussion

Permalink Reply by Aditya Tognatta on March 17, 2016 at 3:43am

Try this out!

Attachments:
Permalink Reply by Mark Eden on March 17, 2016 at 3:51am

Mate you did it! Thank you! Your a legend

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service