Divider

Replies to This Discussion

Permalink Reply by David Rutten on March 5, 2010 at 2:08pm

Which length?

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by adeleh nejati on March 5, 2010 at 2:33pm

For example, I want to divide a surface in a way that each piece's length is 2 feet. What should I do?

Permalink Reply by Mårten Nettelbladt on March 5, 2010 at 2:38pm

Do you want squares?

Is your surface flat (or cylindrical)? Developable?
It may be tricky otherwise...

Can you post your surface as a .3dm or as a screenshot please?

Permalink Reply by adeleh nejati on March 5, 2010 at 2:55pm

My surface is not flat and that is the problem.
I attached the surface for you.
Square sounds good, but is there any way to control both U and V?

Thanks,

Attachments:

• surface.3dm, 35 KB

Permalink Reply by Matt Gaydon on March 5, 2010 at 4:02pm

Hi Adeleh

What out put do you want from the divided surface a set of points like surface divide, a set of surfaces like iso trim or a set of iso curves or even all 3.

Matt

Permalink Reply by Mårten Nettelbladt on March 5, 2010 at 4:39pm

It looks like the surface in your file is a straight extrusion from a curve.
You could create the surface in GH and start by doing a a normal "Divide Length" on the original curve.

Permalink Reply by Ali Tabatabai on March 5, 2010 at 3:30pm

Hi Adeleh,

Does this help? (see attached file)

//A

Attachments:

• quad_surface.ghx, 202 KB