Grasshopper

algorithmic modeling for Rhino

divide surface command

Does anyone know why the divide surface command (u=v=1) creates two sets of two points and not one set of 4 points for the division points? Have they changed the command?
Is there a way of creating a single set of 4 division points and not 2 sets of 2?

thanks!!

Views: 446

Replies to This Discussion

Permalink Reply by trevor.patt on June 14, 2010 at 4:40am
This was changed a while ago, take a look at this discussion:
http://www.grasshopper3d.com/forum/topics/help-with-cull-pattern-cu...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service