Differing floor to ceiling heights...

Hi

I have carried out many tower examples - but all have the same floor to ceiling height (via a slider) - any suggestions on how to use 4m floor to ceiling on the first ten floors and 3m for next twenty and 6m for the final floor?

Thanks

Replies to This Discussion

Permalink Reply by Luis Fraguada on June 3, 2009 at 11:05am

Hmmm, try the duplicate data component with each floor height as the data to duplicate...then merge all of the duplicate data items into one list...The mass addition component could also come in handy as it gives you a list of incrementally added values.

Permalink Reply by James Roberts on June 3, 2009 at 11:29am

I've cracked it thanks! Ended up with a series, stating floor to ceilings and storeys, a second set of this but with the original floor to ceiling and storey height multiplied to give the second series start point instead of zero. this can then be merged and given as the data for the z vector which is moving the floorplates...

Permalink Reply by Luis Fraguada on June 3, 2009 at 12:15pm

nice

RSS